Summer Starts Here - Save up to 70%
Trailer Wiring Harness Installation - 2008 Mazda CX-7- Video
Today in our 2008 Mazda CX7, we're going to be taking a look at an installing the tow ready tow package vehicle wiring harness with four pull flat trailer connector, part number 118249. Here's what this wiring is going to look like once it's installed on the vehicle. As you can see right now, it's not visible. When it's not in use, it's very easy to keep tucked away and hidden, but when you're ready to use it, you can just lift up on the floor of your cargo area and pull it out so then you can use it. Drape it out of the trunk and close the trunk. When you do that you want to be sure to avoid the cargo area here. That's a big no no because it may pinch or damage your wire. more
9/2/2016 2:38:09 PM
Trailer Wiring Harness Installation - 2011 Mazda CX-7- Video
Today, in our 2011, Mazda CX7, we're going to install Part Number 118405. Our wire harness is going to be inside the vehicle. We need open the back hatch and remove some interior panels. It's a good idea to go ahead and clean out your vehicle first before you try something like this. We're going to go ahead and remove all floor coverings. Next, we need to go ahead and remove the trays, one on each side. more
6/2/2014 2:14:42 PM
Trailer Wiring Harness Installation - 2007 Mazda CX-7- Video
Today on our 2007 Mazda CX7, we'll be installing the tow-ready trailer wiring kit, part number 118249. This kit is designed if you have the OEM tow package. The OEM factory tow package port is actually located at the right rear of the vehicle. When you pull the cover off, you can see the wire is bundled up and actually has some black tape holding it in place. It is the white plug that we'll be plugging into. We'll first go ahead and set off the spare tire cover lid. more
10/25/2013 8:03:54 AM
Trailer Wiring Harness Installation - 2010 Mazda CX-7- Video
Today on this 2010 Mazda CX-7 were going to install part number 118405 from Tow Ready. The first thing we need to do is open up the back hatch and remove the interior panels. Well remove the floor coverings, well remove the threshold, and well remove the access panels on each side of the vehicle behind the taillights. With all the panels loosened up we can go ahead start installing our wire harness. Well start on the drivers side and work our way over to the passengers side. Now there will be two connections we need to make on the drivers side, therell be the yellow wire for return signal and there will be the red wire for the brake signal and also the running lights. more
7/25/2012 9:02:36 AM
Trailer Wiring Harness Installation - 2010 Mazda CX-7 118249- Video
Today on this 2010 Mazda CX-7 we will be installing wiring harness part number 118249. The port that we are going to be plugging into is actually located on the passenger side behind the interior panel right behind this access point in here so pull this panel back. By pulling the tape back here we can see the port that we are going to be plugging into. :26 more
12/22/2009 9:23:02 AM
Filter Videos
Filter Videos
